Differences

This shows you the differences between two versions of the page.

--- tools:laser_rabbit:techs [2024/04/12 22:03] – created cookienoyousei
+++ tools:laser_rabbit:techs [2024/04/26 22:31] (current) – [Maintenance & Troubleshooting] cookienoyousei
@@ Line 22: / Line 22: @@
   - Power off the Laser
   - Close Lightburn & don’t forget your USB!
-  - Note any maintenance needs or concerns on the tag and at protohaven.org/maintenance
+  - Note any maintenance needs or concerns on the tag and at [[protohaven.org/maintenance
+|protohaven.org/maintenance
+]]
 Consult the [[tools:laser_rabbit:start|main page]] for more information.
@@ Line 38: / Line 39: @@
 **[[tools:laser_rabbit:maintenance|Maintenance page]]**
-  * One of the most common issues is the lens and mirror get dirty after frequent use
+  * One of the most common issues is the lens and mirror get dirty after frequent use.
-  * The laser may also be bumped out of alignment.  Test this by checking a shape near the rear left of the bed (closest to the laser tube) and the front right (furthest).
+  * The focus distance to the material might be incorrectly calibrated.
+  * The mirrors may also be bumped out of alignment.  Test this by checking a shape near the rear left of the bed (closest to the laser tube) and the front right (furthest). If the mirrors are out of alignment, see someone who knows how to adjust them per the directions on the maintenance page.
 ====== Safety ======
@@ Line 45: / Line 47: @@
 **Common Hazards**
-^Fire ^ Toxic Fumes ^ Lens Collision^
+  * Fire
+  * Toxic Fumes
+  * Lens Collision
 Check to make sure the material is acceptable.