Differences

This shows you the differences between two versions of the page.

--- tools:metal_shear:clearance [2024/02/13 12:52] – smartin015
+++ tools:metal_shear:clearance [2024/03/21 11:54] (current) – smartin015
@@ Line 1: / Line 1: @@
-====== Metal Shear Clearance (STUB) ======
+====== Metal Shear Clearance (DRAFT) ======
 {{section>tools:clearance_template&noheader&nofooter}}
 ====== Tool Specific Instruction ======
+TODO
 ===== Point out the following tool features =====
@@ Line 24: / Line 26: @@
 TODO
+===== Notes =====
+  * Measuring - via the guard/stopper on the back for repeated cuts. Can lock both sides via the black levers on the ends. 4ft wide stock.
+  * Too small of pieces fall down into the machine, better off to add a spacer piece to keep thing from falling
+  * To remove pieces that fall in - remove the back plywood board and dig
+  * Plywood outfeed board catches stuff so it doesn't slam onto the floor.
+  * Confirm both E stops (on machine and on pendant) are disengaged
+  * Make sure plugged in, Turn red lever to turn machine on
+  * Pump start button, runs the hydraulic pump
+  * Push metal to the guard, step on the pedal
+  * Be sure to clean up and turn main power off when done
+  * SIN - auto retracts, single cut
+  * INCH - holds position when you tap
+  * AUTO - repeats the cutting operation as long as you hold it down
+  * Upgrades
+  * Add a sheet metal cover to prevent stuff from falling in.
+  * Drop superglue onto light switch to ensure it stays on
+  * Replace power LED indicator so there's a light that turns on