Differences

This shows you the differences between two versions of the page.

--- tools:metals_slip_roll:clearance [2024/02/13 12:56] – created system
+++ tools:metals_slip_roll:clearance [2024/03/21 11:54] (current) – smartin015
@@ Line 1: / Line 1: @@
-====== Electric Slip Roll Clearance (STUB) ======
+====== Electric Slip Roll Clearance (DRAFT) ======
 {{section>tools:clearance_template&noheader&nofooter}}
@@ Line 24: / Line 24: @@
 TODO
+===== Notes =====
+  * check your sleeves & loose fabric - bad!
+  * Don't do rod or tubing. Sheet metal 16ga only
+  * Blue bar is emergency stop, works in either direction
+  * Lower idler roll in the back with the black handles - match sizes
+  * Want metal going in and up, not digging in.
+  * Back out both E stops (on machine and on pedestal)
+  * Press power button, green light turns on
+  * Make sure tension knobs on both sides are consistent - for top and bottom front roller
+  * In/out step levers
+  * Pull the lock on the right side of the top roll out to allow removing fully rounded pieces. Make sure to lock it afterwards!
+  * Drill slip controler
+  * Maintenance:
+  * Every month - apply ways oil (from oil can resting on lathe) to metal bushings on idle roller. Spin the roller to make sure it moves freely