Differences

This shows you the differences between two versions of the page.

--- tools:mig_welder:clearance [2023/11/24 15:57] – smartin015
+++ tools:mig_welder:clearance [2024/02/07 23:30] (current) – smartin015
@@ Line 1: / Line 1: @@
-====== MIG Welder (and Plasma Cutter) Proficiency Based Clearance ======
+====== MIG Welder Clearance (STUB) ======
 {{section>tools:clearance_template&noheader&nofooter}}
@@ Line 7: / Line 7: @@
 ===== Point out the following tool features =====
-MIG Welder (TODO)
+TODO
-Manual Plasma Cutter
-  * Maintenance tag
-  * Power switch
-  * Air inlet
-  * Torch connector
-  * Ground connector
-  * Ground clamp
-  * Amperage selector
-  * Torch retaining cap
-  * Torch nozzle
-  * Torch electrode
-  * Torch start trigger
 ===== Identify & mitigate common hazards =====
-  * Electrical - Piece must be grounded. Don't work with wet or conductive clothing/accessories/PPE or have exposed skin.
+TODO
-  * Heat & Plasma - welding jacket, gloves, and face shield required to avoid burns from torch & hot metal
-  * Light - welding face shield needed to prevent UV burns and blindness
-  * Noise - wear hearing protection
 ===== Allowable Materials =====
-  * Can name two materials that can be plasma cut
+TODO
-  * Can name three materials that cannot be plasma cut
 ===== Safe Setup/Operation/Cleanup =====
-Plasma Cutter
+TODO
-  * Demonstrates proper setup of stock to be cut
-  * Demonstrates proper shielding of the area to prevent bystander arc flash
-  * Demonstrates proper attachment of air line and ground clamp and turning the machine on
-  * Demonstrates proper wearing and adjustment of PPE
-  * Demonstrates striking an arc and making a freehand cut fully through the material
-  * Demonstrates proper cleanup and storage of the plasma cutter, including disconnecting and storing the air line
 ===== Knowledge and Technique =====
-  * Knows the signs of worn out plasma consumables while cutting and can check them for wear
-  * Can demonstrate taking out and replacing the nozzle and electrode
-  * Knows at least 2 sources of reduced edge quality and slag production
+TODO